Skip to Content
avatar image
Former Member

SM Wily Introscope Version 8 doc question

We also installed Wily Introscope Version 8, however there was a part mention as below

The Solution Manager Diagnostics provides an application that performs the setup of the

Introscope bytecode agent for Java automatically. This section explains the steps to run

the setup. Before you can run the Introscope agent setup, the setup wizard for the

managed system must have been executed.

1. Enable Maintenance Mode on SMD.

2. Deploy ISAGENTSMD*.SCA using SDM.

3. Disable Maintenance Mode on SMD.

4. Launch the Introscope Setup application: Diagnostics Setup -> Managed Systems ->

Introscope Agent. Your screen will look similar to the image below:


1) How do I go into SMD ? I did use http://<SMserverFQDN>:50000/smd however I only get a header but blank content body in IE or FireFox? Where do I enable maintenance mode?

2) Where do I launch the Introscope Setup Application: Diagnostics Setup ?

I can't find it under Introscope workstation console.


Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • Sep 01, 2010 at 08:11 PM

    What's the SP level your solution manager ?

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Sep 02, 2010 at 03:23 AM


    Regarding your questions, please kindly check

    Root Cause Analysis Installation and Upgrade with SOLMAN_SETUP



    Hope this helps.



    Add comment
    10|10000 characters needed characters exceeded