Skip to Content
avatar image
Former Member

reg sampling scheme and defects

Dear all,

My requirement is for a machinary of 10 units even if one is not as per spec total lot should be rejected, I tried to use sampling scheme where I have selected . Attributive insp and Insp.severity/AQL and in sample size I gave lot size-10 , in C gave value of 0 and in d1 gave value of 1 remaining all c2,d2,c3,d3 put as 0, in sampling procedure selected sampling type-300 use sample scheme and in Valuation mode-200 Attributive insp number of defects and in control indicators gave single values with fixed scope

Eventhough in a lot of 10 for 2 values which are in rejected sysytem is giving valuation as accepted, what is to be done

Please advice, thanks in advance

Regards

venkat

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Best Answer
    avatar image
    Former Member
    Aug 19, 2010 at 02:08 PM

    Hi Ventak,

    Think twice before going to map such scenario's, if u realy looking for close lot if any one MIC rejected then explore below things

    Run t code QCC0 ---> Defect recording ---> Define report type ---> Assign Report Type to the Work Center ---> enter * in work center and activate Sub system indicator for particular plant.

    Activate defect recording indicator at MIC level. So that whenever MIC is rejected system will popup window, for defect recording

    Here enter code and code group for Rejection due to dimn

    Use followup action to close this lot by passing UD code (If u can set auto stock posting through UD code)

    Check with this scenario

    Add comment
    10|10000 characters needed characters exceeded