Skip to Content
avatar image
Former Member

Product category replication after system refresh

Hi Gurus,

Recently Our sandbox system was refreshed with production data. Both ECC and SRM were refreshed. While testing a shopping cart, I noticed that product categories were not found and hence cannot create a SC.

I checked the config, ports, and validated the BDLS; everything seems to be ok.

I thought when system is refreshed, all data will be copied(prod categories). Please advise if I am missing anything or if I have to replicate the prod categories again.

Regards

Rao

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Best Answer
    Aug 17, 2010 at 09:43 PM

    RHOMATTRIBUTES_REPLACE run this report.

    prcat (PRCAT is a attribute for product category) string check box

    old logical system :from where copied logic system

    new logic-- new logical system

    and select all record replace

    Muthu

    --

    PS:- see extended attribute it might pointing to unwanted logical system description.

    you may need to all attributes which points to old logical system like cost center(CNT) , acs, sys.. clue SEE INHERITED ATTRIBUTE tab

    and correct all logical system by the baove report.

    in THE ECC system CRMRFCPAR might pointing to old logical srm system that you need to correct and see SETTINGS IN smoeac BOTH SITES ...

    Add comment
    10|10000 characters needed characters exceeded