Skip to Content

Sample size v/s sample usage

Hi Experts,

When I am maintaining a sample drawing procedure and sampling procedure, as per that the inspection lot is calculating the sample size and appearing in QA32 with a released status. But I have also maintained formulas and additive/destructive indicators in the inspection characteristics of inspection plan. So when I am saving the results system is calculating sample usage as per above mentioned formulas and indicators. Finally there is always a difference between the sample size and sample usage in UD screen. I want both to be equal to the sample usage as calculated after result recording. Is it possible?

Regards

Sm

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Aug 18, 2010 at 09:42 PM

    Sample size is derived from plan whereas the usage depends on additive/destructive indicators. This led to the difference, The issue is resolved.

    Regards

    Sm.

    Add comment
    10|10000 characters needed characters exceeded