System status WCRE is active (ACT #2)

[Former Member]

dEAR SIR

When iam doing production order creation by co01 iam geting error as shown below

System status WCRE is active (ACT #2)

Message no. BS013

Diagnosis

Object ACT #2 has system status WCRE (Work center until release). According to this status, transaction 'Release operation' is not allowed.

Procedure

You can only carry out the requested function if this is allowed according to the status of the object.

pl give solution

regards

Baswarj

[rupesh_brahmankar3 · Accepted solution]

Dear,

WCRE - Indicates Workcenter Until Release.

Please check the status of you work center CR02 it should not be locked or active for deletion flag also the usage as 009. Also check the setting of OP45.

Go to BS22 transaction for "I0270 - WCRE Work center until release" double click and for release make it allow.

Refer this thread,

Regards,

R.Brahmankar

Edited by: R Brahmankar on Aug 11, 2010 1:54 PM

[former_member196530]

Dear ,

This is due to Work Centre is locked in CR02.Goto CR02-Work centre -Adminstrative Tab-Check if the Lock is marked or flagged on .Unlock the same and SAVE the work centre

Check in SAP T-code BS22 transaction -Select the status WCRE - Double click and mark it for Allow option.

Try and come back

Regards

JH

[Former Member]

Dear Basawraj,

I think this duplicate thread has been created mistakenly so close this and check the reply to other thread of your's

Regards

Madhu