PI to MDM data missing - Data not found on relevant inbound port in MDM

[Former Member]

Hi,

I am trying to push data from PI 7.11 to MDM 7.1. Message is successful in moni and communication channel monitoring shows status as "Message processing completed successfully" but data is not found on the relevant inbound port on MDM.

Did anybody face this kind of issue. Please help.

[prateek · Accepted solution]

Which adapter are you using? Open the audit log and you would be able to find out the steps which were complete.

Regards,

Prateek

[Former Member · Accepted solution]

Hi Prateek,

I am using MDM PI adapter. In the audit log it shows all the steps as successful.

Here is the audit log of the receiver communication channel -

Here is the receiver mdm cc log u2013

2010-08-10 03:29:03

Information

Processing child message of multi-message with message Id 80144f4a-c0fa-1ddf-a985-ed8433479848.

2010-08-10 03:29:03

Information

Using connection MDM_http://sap.com/xi/MDMAdapter. Trying to put the message into the receive queue.

2010-08-10 03:29:03

Information

Message successfully put into the queue.

2010-08-10 03:29:03

Information

The message was successfully retrieved from the receive queue.

2010-08-10 03:29:03

Information

The message status was set to DLNG.

2010-08-10 03:29:03

Information

Delivering to channel: CC_MDM_ALEAUD01_Out

2010-08-10 03:29:03

Information

The message was successfully delivered to the application using connection MDM_http://sap.com/xi/MDMAdapter.

2010-08-10 03:29:03

Information

The message status was set to DLVD.

[rajasekhar_reddy14 · Accepted solution]

Hi Sudheer,

The problem looks from MDM end,because Receiver Communication channel showing status success.

search in mdm forums or post thread in mdm forums,you might get usefull info

Regards,

Raj

[Former Member · Accepted solution]

Thank you Raja for the information. Yes it seems the issue is from MDM side.

[Former Member · Accepted solution]

Hi Sudheer,

you should check the module configuration of the MDM receiver channel. It cannot be empty.

If a channel was activated as 'sender" and then later changed to "receiver", the module configuration can get lost.

Regards,

Gábor

[Former Member · Accepted solution]

Gabor,

The module configuration is not empty, as I said the receiver channel has successfully processed the message, how can the channel execute the message if the module configuration is empty.

This is what I could see under module tab of receiver channel -

1 localejbs/CallSapAdapter Local Enterprise Bean exit

[Former Member · Accepted solution]

Hi,

Have you given the correct JNDI value to the exit ke? I have faced the same problem and was solved by correcting it.

Prasanna.

[Former Member · Accepted solution]

Hi Prasanna and Gabor,

Thank you for the help. The problem is solved now. JNDI is missing under the module configuration. I have done the required specified in note#1336552.

[rajasekhar_reddy14]

Hi Sudheer,

Which adapter are you using to send data MDM-PI adapter or File adapter??

which communication channel you have monitored,if receiver communication channel monitoring showing status successful then problem with MDM side.

Regards,

Raj