TUBS 181

[Former Member]

Has anyone been able to apply TUBS 181 without having the system at the minimum support pack level?

And if you have, what course of action did you take. This would be very helpful.

Regards, Sal.

[felipegrandi · Accepted solution]

Unfortunately there's no way. In order to apply TUB 181 you need to apply the notes as follows:

1) Apply note 1402100

.sar file

correction instruction

manual steps

2) Apply note 1479550

.sar file

correction instruction

3) Apply note 1479549

Just the Manual Steps

4) Apply note 1474953

.sar file (can be found on Service Marketplace)

And in order to apply them you need to upgrade your system.

Kind regards,

Felipe Grandi

[Former Member]

Thank you Muthu for your response. We cannot apply the pre notes because we are not at the minimum HR support pack that will support these notes, and TUBS 181. I was wondering if anyone is below the required support pack 48 and was able to apply through some sort of advanced correction given by SAP. Regards, Sal.

[Former Member]

Hi,

We are also facing same issue? any solution for this?

[Former Member]

Thank you Arti, Unfortunately we are at svl 32. I don't believe SAP will have any advanced corrections for such a low svl. I was just putting feelers out there to see if there where any folks who are at lower svl levels than required. Thank you for your response. Regards, Sal.

[Former Member]

HI Salvatore ,

you need to apply below prerequisite notes in sequence before applying tub 181 as per SAP recommendations

1.1402100

2.1479550

3.1479549

Thanks

Muthu

[Former Member]

Hello Salvatore,

We applied TUB 181 last week. We are support stack level 48 and didn't encounter anything unusual.

What is your support stack level?

Arti