Euipment Record Replication From SAP PM system to SAP CRM

[Former Member]

Hi ,

As per my Business Scenario Equipment Record created in SAP PM system will be replicated as Objective Id for the Installed Base Component & at The same time Installed Base hierarchy will be created ..for this process we have schedule a BATCH JOB which run daily basis.....

Issue Now my Client wants delete some Installed base Items from SAP CRM system ... for that we have set the Status of Equipment was Deletion Flag status in SAP PM system.

Still we are able to see Equipment Record (Installed Base Objective) in SAP CRM ..like Active status...

Do we have any solution delete those records permanently from SAP CRM system..as well as SAP PM .

Wards Regards

Nagaraju Ravipati

[Former Member · Accepted solution]

Hi.

Can you please help me on the necessary steps to download equipments and serial numbers form R3 into CRM?

I am new on this and I have had no success until now.

Thanks.

Regards.

Susana Messias

[Former Member · Accepted solution]

Hi,

The pieces of EQUIPMENT in SAP r/3, CS or PM are represented in SAP CRM as objects of an installed base. To get started on how to integrate these two systems and downloand the Object ID's and Serial Numbers to CRM you can refer to the below link

http://help.sap.com/saphelp_crm60/helpdata/en/46/cc79505ec61525e10000000a114a6b/content.htm

Kind Regards

Kshitij Garg

[Former Member · Accepted solution]

Hello Nagaraju,

If you want to delete the individual objects from CRM,

they you can use the standard reports like COM_PRODUCT_DELETE_SINGLE and COM_PRODUCT_DELETE_ALL.

But please make sure that these Ind Objects are not used anywhere i.e within transaction data or IBASE etc which might

create inconsistencies later.

If you are very sure that Ind Obj is obsolete, then you can go ahead with the report.

Please obsever that before executing the report, you have to make an entry in table COMC_PR_TOOL_REG.

Hope this helps!

Best Regards,

Shanthala Kudva.

[Former Member]

Hi Ravipati,

In the Standard scenario the Delta load for Equipment object is set to inactive. To activate this feature u need to go through the note 637173. You can also refer to the below link for details on EQUIPMENT replication procedures.

http://help.sap.com/saphelp_crm60/helpdata/en/46/cc79505ec61525e10000000a114a6b/content.htm

Regards

Kshitij Garg

[Former Member]

Thank you vary much..it helps me a lot