cancel
Showing results for 
Search instead for 
Did you mean: 

Does solution manager 7.1 supports monitoring of Netweaver 7.5?

0 Kudos

Hello All,

We need to configure some systems which are on Netweaver 7.5 and we are using Solution Manager SP13. Does this version of solution manager supports monitoring of Netweaver 7.5?

Anyone know anythis about it........

Thanks

Accepted Solutions (0)

Answers (3)

Answers (3)

cpintogacio
Advisor
Advisor
0 Kudos

Hi all,

As Shahid says, this is probably caused by an outdated Monitoring Content installed in the system. I highly recommend you to look up the following SAP KBA:

2351440 - SOLMAN_SETUP: Missing installed products in step “6. Setup Monitoring”

I would also recommend you to pay special attention to the last part of the KBA, where is explained how to resolve the problems related to the RCD content.

Regards,

Carlos

former_member185326
Active Participant
0 Kudos

Hi Aditya,

NW 7.5 monitoring templates (especially Java based) are supported from SAP Solution Manager 7.1 SP14. Also, make sure your monitoring content is up to date in solution manager.

Updating CR content and monitoring content is a must to avoid such issues.

Regards,

Shahid

0 Kudos

Hi Shahid

I have tried a lot of correction and notes but my issue is still there as i am not able to assign templates to the instance.

kindly suggest some solutions.

Regards

Aditya Singh

former_member185326
Active Participant
0 Kudos

Hi Aditya,

Can you check in Step# 2.7 (Update Content) of technical monitoring guided procedure? If the content is updated or not. If not, please update the content. If issue persists, I suggest you check the landscape verification for this system in LMDB.

Regards,

Shahid

prakhar_saxena
Active Contributor
0 Kudos

Hi Aditya,

The answer to your query is in below SAP notes.

2308312 - No licenses information for Java AS NetWeaver 7.5 system

1478974 - Diagnostics in SAP Solution Manager 7.1

Hope this resolves

Thanks

Prakhar

0 Kudos

Hi Prakhar

Thanks for the reply. The Notes were very helpful.But even after following the steps suggested in Notes we still have the issue. There is no option to assign any template to instance. i am attaching the screenshot.

please reply

0 Kudos

Hi Prakhar

Even after following the notes i am not able to rectify the issue. It still not showing any template to assign. Kindly suggest some other solution.

prakhar_saxena
Active Contributor
0 Kudos

Hi Aditya,

You need to upgrade to Solman 7.1 SP14 or 7.2 as per notes shared already, have you done that?

Thanks

Prakhar

0 Kudos

Hi Prakhar

It is given in the note that there is support for Netweaver 7.5 ABAP in Solman 7.1 SP13 and we are on the same level.