on 07-22-2010 10:38 AM
Hello
I apologise if this question has been asked before as it seems an obvious one, but I have been unable to find the asnwer.
We are creating documents in PLD and would like to be able to set width, height etc settings in millimeters rather than pixels. Where can this setting be made?
Thank you.
Regards
Hi,
PLD has only one UoM which is pixel. If you would like to get number to corresponding mm, check the paper size under Document Property of PLD. Simply divide the total pixels of total width/height by actual mm for paper, you will get the ratio.
Thanks,
Gordon
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi
Go for Some millimeter to pixel online converters and get the corresponding value to enter in pld
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
90 | |
8 | |
7 | |
4 | |
4 | |
3 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.