cancel
Showing results for 
Search instead for 
Did you mean: 

Production Order Compoent Rounding with a Scrap Factor

Former Member
0 Kudos

Hi all,

We are using a 3 decimal unit mesure. And I'm having a problem when the component have a Scrap factor.

Instead of rounding up to the nearest whole number it is keeping the decimal place so a component with a scrap factor of 1% and a requirement of 10 come out to 10.1 in the production order instead of 11.

Does anybody know of a userexit, BADI or other solution?

Points will be given

Thanks

Accepted Solutions (1)

Accepted Solutions (1)

former_member196530
Active Contributor
0 Kudos

Dear

Changing directly the base UoM of components related with component scrap may not work either as far as I have read and according to the note SAP 931971.

Otherwise , try to check Decimal places and rouding of decimal place is maintain properly for the base unit of measure of that component in T.code CUNI. Is there any Rounding value (value = 1) is maintain in MRP 1 data of that component ?

I think , you should keep Decimal Place Rouding field in CUNI -Conversion Tab -as 1 or 2 if you want to round to 10.1 as 11

Try and revert

Regards

JH

Answers (0)