Skip to Content
avatar image
Former Member

Idoc to FI scenario - Help needed

Hi folks,

Scenario: Idoc to file:

I am trying to push COSMAS01 from SAP R/3 systemt to PI 7.1. I did the following

1> Configured the IR and ID

2> Did the ALE config on the sender R/3 system and also pushed idoc using BD16. I also see the status of the idoc as 03 (Send to port ok). However when I run IDX5 and SXMB_MONI, I dont see any message . idoc received.

Let me know where do I check to troubleshoot this issue.

I also have a doubt, Do I need to distribute the model from BD64 to from R/3 ? Is it needed?

-- AKJ

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • avatar image
    Former Member
    Jul 21, 2010 at 06:04 AM
    Add comment
    10|10000 characters needed characters exceeded

  • Jul 21, 2010 at 06:08 AM

    Hi Amit,

    Please check in tcode SM58(TRFC Monitoring) of R/3 System.

    Go to SM58

    if there are any messages then there is some error in execution.

    Goto WE02.

    Check the status of the IDOC.

    Goto WE47.

    TO decode the status code.

    For More Help..Refer This Blog..

    /people/kamalkumar.ramakrishnan/blog/2008/02/13/monitoring-the-idoc-adapter-in-xipi-using-idx5

    Regards

    Jyothi A

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Jul 21, 2010 at 07:07 AM

    Hi Amit,

    Check in SM58 tRFC queue for any entry..if everything is fine there thn chk whether the file is received by the end system or not.

    If file is received and you are not able to see msg in Moni then chk the parameter entry in SXMB_ADM logging and loggin_sync.

    Regds,

    Pinangshuk.

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Jyothi Anagani

      Finally I managed to see the output file generated from Idoc. However the mapping did not happen correcly.

      I tested it in Message Mapping and it was showing ok but the actual is not good

      Where do I see the mapping Conversion (Occured thru File content conversion) because I do not see the inbound (output sise) XML in SXMB_MONI.

      -- AKJ