Skip to Content
avatar image
Former Member

Excise invoice under No bond

I am trying to create an excise invoice under no bond, system giving a message No Enough balance for utilization.

Where as there is sufficient balance available in rg23a registers

We are getting this error when i am trying to save the document

Pls do the needful

Regards

Suresh

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Jul 21, 2010 at 04:12 AM

    Kindly check the CIN customization for Utilization Determination under CIN customization.

    Check if you have not done the setting for RG23A and RG23C.

    Here you can set for all the register as blank instead maintaining 100% .

    Other option is to have maintain the percentage based based on your requirement.

    Also check under J1IIN utilization screen click on BALANCE Icon and check for all the register has got enough balance for utilization.

    If you don't have enough balance in any of the above mentioned register then system by default takes it from PLA register.

    Thanks & Regards

    JP

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      Thanks for the reply

      I have been able to carry excise utilization under No bond earlier without any problems

      All the configuration settings are also fine no changes in it

      In J1IIN too when I am click on the balance Icon system is showing sufficient balances in RG23A

      Regards

      Suresh