Reg:- PCR

[Former Member]

Dear Freinds,

I need to write a PCR for GOSI u2013International Payroll as below,

For Employee Group A i should assignee as below

Employee Contribution: - 09 %

Employer Contribution: - 11 %

For other than A group

Only employer contribution: - 2%

Please help how to write the PCR for above the same and where to plug in the Schema

Your help will be highly appreciated

Thanks

Magesh.

[sikindar_a]

Do you want system to calculate the amount automatically ?

and on which wage type you want to caluculate the percent

[Former Member]

Hi,

based on this percentage system should automatically calculate it ,

Thanks

[Former Member]

Hi,

Based on the percentage system should automatically calculate it during the payroll run.

The 9% will be dervied as below

100% from Basic Wage type (1000)

25% From the HRA Wage type (1005)

Thanks

Edited by: Sam on Jul 17, 2010 1:36 PM

[gangadharrao_tenneti]

Didn't get you what is 100% from Basic and 25% from HRA?

can you give an example if a employee Basic is 1000 and HRA is 500... how the GOSI calculation?

[former_member193210]

If I understood you correctly, you could use the valuation base to generate WT GOSI (Valuation Base for GOSI). If I remember correctly, through V_512W_B you set-up WT 1000 to generate WT GOSI at 100%, and you set-up WT 1005 to generate WT GOSI at 25%. So WT GOSI will be a total of 100% of 1000 and 25% of 1005.

In V_T511K, you set-up 3 constants for your contribution rates: ZGOS1 = 9.00 ZGOS2 = 11.00 ZGOS3 = 2.00

You could have a WT for the Employer's contribution to GOSI, and an other WT for the employee's contribution to GOSI, or a single WT (CONT) for all the contributions.

In a Payroll PCR, you will need to make the following decisions:

- identify if the employee is in Group A or not;

- identify if the WT being processed is 1000 or1005 (and there are a few ways to do it);

- you may also require a decision to delimit the new functionality (with operation CMPER);

and then, as a first operation, return all WTs to the input table (ADDWT *), and if your are processing WTs 1000 or 1005 you define the rate as the constant (RTE=KZGOSx) multiply the rate by the amount and enter the result in the amount field (MULTI RAA), divide the amount by 100 (amt/100) and transfer the result into the GOSI Contribution WT (ADDWT CONT).

[Former Member]

I appreciate and Thanks .