Skip to Content
avatar image
Former Member

BADI to convert Purch reqs of subcontracting type to standard Pur reqs

Hi Experts,

We have a subcontracting scenario in ECC. The master data is transferred to APO and purchase reqs of subcontracting type are generated. We have a requirement to convert these purchase requisitions of subcontracting type to standard pur reqs during transferring them from APO to R3 through CIF.

Please share your thoughts to map this scenario? Is there any BADI/enhancement available for this?

Regards,

guest201

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • Best Answer
    avatar image
    Former Member
    Jul 15, 2010 at 08:54 AM

    Hi,

    Have a look to CIFPUR02 user exit (ERP).

    Regards,

    Alexander

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Jul 15, 2010 at 08:37 AM

    Hi,

    If you convert the subcontracting PR in APO to normal standard PR in SAP R/3, there will be still anamoly within the two PRs between APO and SAP R/3 systems.

    It is expected to have relevant data synchronized between the two systems.

    I think, you may have to revisit the business process, and check if really subcintracting is to be mapped in APO or not.

    Regards

    Datta

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      In a subcontracting scenario, you or some third party will normally supply the components to the subcontracting vendor to produce the FinshedGood.

      In APO, you do the subcontracting scenario setup to determine the Dependant demand on the components which either you produce in-house or in your case-procure from another vendor.

      I am assuming the following here: In APO, subcontracting setup is completed (SUBCONTRACTING TLANE, PPM OR PDS at SUBCONTRACTING LOCATION)

      If you have the above setup, then it will generate a Subcon PR as demand on the Subcontracting location against which a Subcon Planned order will be generated which will explode the components.

      You can do planning on the components and procure them from another vendor by setting up a TLANE.

      Now a question for you: If you change the SUBCON PR to a normal PR, how will the SUBCONTRACTOR receive the components if it is not a SUBCON PO?

      THanks

      Kumar

  • avatar image
    Former Member
    Jul 15, 2010 at 08:52 AM

    Hi ,

    You can do the same by using the user exit from APO to R3 and hardcoding the change of order category from LB to NB. However it is strongly not recommended as the moment you will change from subcontracting pReq to normal preq , the dependent demand for the components will not be seen and hence the business process of subcontractig is not mapped.

    In case of subcontracting it is required to generate demand on components for getting your finished tolled product.

    Can you let me know why would you like to convert the same ?

    Let me know if it helps

    Regards

    Gaurav

    Add comment
    10|10000 characters needed characters exceeded