Mixing Batches

[Former Member]

I'm having the material i.e solvent qty in one batch number. I received same material with other batch number. That receiving batch number will go to Quality. After analysis we will mix the two batches i.e previous one and received one with a new batch number. While mixing i activated QM '08' inspection type. While doing MB1B i'm getting two lot numbers. But i need only one lot number. How can i?

[Former Member · Accepted solution]

Hi Narendra,

Please set following settings in the Material master QM view to get the Single inspection Lot for when you mix the multiple batches

In Material master QM viewInspection Set up_*08-In the Control ins lot --select the 1-For each material document, material , batch,stotrage location*

Thanks,

Rajanikanth

[former_member42743]

I dont think you can. 08 is triggerred by the material movement. Since you used the same material movement for each batch, you get two lots.

Technically, you should be combining these with a process order. And inspecting the new batch with an 04 lot.

FF