Skip to Content
Former Member
Jul 14, 2010 at 12:39 PM

SPAM/SAINT update issue before and after EHP4


We tried to update the SPAM/SAINT package after the installation of ECC 6.0 EHP4 Ready system.

Here are few steps which we have performed on the system even before EHP4 installation.

1. we tried to update the SPAM before moving with EHP4 installation however it did not completed and when logs seems to be proper. We reset the queue with Function Module OCS_RESET_QUEUE using Tx se37 .

2. The spam status went to green with updated version

3.We moved ahead with the EHP4 installation assuming that installation will fix the SPAM issue. After the installation completed the SPAM status was green with the new version , however when we exectuted the import spam/saint it again went to the PROLOGUE state.

Please let us know if we can use the system productively as we have performed these steps without the SAP support , also there are no errors at the ST22 other than originated by the spam tx.

Please find the attached trans log

Please advice....

Also , the show buffer command shows following output..

D:\usr\sap\GCQ\SYS\exe\uc\NTAMD64>tp showbuffer GCQ pf=


This is tp version 375.94.95 (release 701, unicode enabled)

GCQ buffer:

SAPKD70139 | | |has already been imported completely


that makes 0 transports to be imported.

tp finished with return code: 0


Everything OK

Edited by: indian tiger on Jul 14, 2010 3:03 PM