Skip to Content
avatar image
Former Member

Best scenario to use variable inspection and attributive inspection

Hello!

Can anyone help me with a practical example of difference between attributive inspection and variable inspection by s-method? What are the best scenarios to use them repectively?

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • avatar image
    Former Member
    Jul 14, 2010 at 06:24 AM

    variable inspection :Variable inspection is in SAP terms Quantitative inspection means have some value which is variable & can be measured .Examples can be very wide range like say in mechanical companies like auto industry components needs to be inspection in micron with Upper & lower limits.Like 12 mm + 0.001 / - 0.002 etc.

    These could be the scenarios where you need to comply with upper & lower limits.

    Attributive inspection:In SAP terms its Qualitative type means can not be measured but can be derived or compared.Like Go-NoGo gauge,Yes -No ,Pass-Fail etc etc.

    scenarios are mostly in mechanical or Elec industry where such values need to be monitored.Like say A equipment pass or fail in a certain test char. or say a component has surface finish problems etc which can only be seen or compared.

    Add comment
    10|10000 characters needed characters exceeded