MIC vs. Class Charact, link failure

[Former Member]

Hey Gurus,

I created a class characteristic, assigned it to a class then assigned the class to the material.

After that created an MIC, linked it to the class characteristic.

Then created the inspection plan for my material.

I purchased the material, the lot created, I entered the results and made the UD, but the class characteristic was not updated !!!

How can I resolve this ?

Regards,

MaX

[Former Member · Accepted solution]

Check for the config setting at plant level - batch valuation without material spec is turned on or not. If you are not inspecting a material with Material specifications, you need to trun this indicator in order to flow the recorded results to batch master.

Thanks,

Ram

[Former Member · Accepted solution]

Thanks RAM

[Former Member]

Hi,

In material master --Additional data -- Praportion data --maintain same class charecteristic ( planned value 100 % ) --praportion unit A

Just try I think it will work for you .

Try for new inspection lot

Regards

SANIL