on 07-12-2010 7:15 AM
Info Package:
Created an infopackage.
Update: initialize Delta wiht Data Trasfer.
Shows and error saying init request *** is running.
Unable to load data, not create delta queue.
Please advise
Delete init. request REQU_D8FW3TPS88PNV0AY64R17N9BS before running init. again with same selection
Message No : RSM1188
Hi Raj,
There should be only one Init in the IP. But there is already one Init request "REQU_D8FW3TPS88PNV0AY64R17N9BS" present & you are trying to load one more init because of which you are getting this error.
You will have to delete the earlier init request "REQU_D8FW3TPS88PNV0AY64R17N9BS" before doing the new init. then do the new init load. Once the new init load is done, you change the update mode to delta & save the infopackage so that it will pick up only delta from the next load onwards.
Hope it helps!
Regards,
Pavan
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Resolved
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Yes, I tried the above. But the the init will not be succesfully.
I ll get the message Data was requested.
Later when checked in DSO, no data.
Checked monitor and found error;
Dso not activated, and if I try to activate data manually, thru the same error as init request is already running.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Raj,
The message RSM1188 it self tell you to delete the old init request which is not in success.
RSM1188 :Delete init. request &1 before running init. again with same selection.
Delete the init request and do the fresh re init.
goto infopackage menu --> scheduler -> Initializaton options for source system.
Delete the bad init request and go for the reinitialization.
Regards
KP
Edited by: prashanthk on Jul 12, 2010 8:45 AM
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Find the init request. It is probably red, but the status is still running. Change the status to red. Delete the request and then rerun the init.
Regards.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
GO to the Infopackage. In the menu in scheduler -> Initializaton options for source system.
THere you will find the old init request.
Delete it and then run a fresh init.
Regards,
MD
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
94 | |
11 | |
11 | |
10 | |
9 | |
7 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.