Skip to Content
Former Member
Jul 08, 2010 at 01:59 AM

How to update new data to 2LIS_02_ITM


Hello dear all,

I have created a new PO in the ECC side, when I used RSA3 to check 2LIS_02_ITM datasource which is nothing in there. After then, I went to the LBWE to schedule control job immediately, i saw extractor queue transport to BW queue ( I used RSA7). But after then, I tried to use RSA3 to check this datasource again, it is same as before. So do some one kow how to pull data to 2LIS datasources in the ECC side?