Skip to Content
0
Former Member
Jul 02, 2010 at 09:08 AM

Performing Automated Configuration after upgrade from CE 7.11 to 7.20

22 Views

Hi Gurus,

I have upgraded our CE 7.11 system to CE 7.20 by following the Guide: Update Guide CE 7.2 (Update from CE 7.1/CE 7.1 EHP1) - SP02.

In the Chapter 4: Follow-Up Activities, section 4.5 mentions "Performing Automated Configuration".

My confusion here is, do I really have to run this Automated Configuration?

This guide says:

Do not use the functional unit configuration tool to configure functional units that have already been enabled after:

-Upgrade

-Update

-System copy

If you need to change the configuration of functional units that have already been enabled, then you must execute the configuration steps manually

If you want to use a functional unit that has not previously been enabled, you can either use the functional unit configuration tool or execute the steps manually.

But SAP Help Library link: http://help.sap.com/saphelp_nwce72/helpdata/en/45/a3c3f043cb0cf0e10000000a114a6b/frameset.htm says:

Use the functional unit configuration tool to perform the initial setup of functional units of SAP NetWeaver CE.

Do not use the automation tools after:

-Upgrade

-Update

-System copy

If you need to change configuration of already enabled functional units, carry out the configuration steps manually.

Do I need to run these tasks or not?

Thanks,

Shitij