Skip to Content
avatar image
Former Member

how to move the stock after quality inspection in wm

hi ,

if i am posting GR with PO for the material XXXX quantity of 10 it should not be posted in Warehouse. after completion of stock inspection in QM then only it moved to warehouse . But the problem is when i post gr in migo the transfer requirement created automatically...if i make this TR manual, two posting occurs one for gr posting and another one for manual to control this....

ex: matxxx-10 quantity

migo posted(no stock should be posted in wm)

after qc--8 quantity o.k

then we need to move this 8 quantity to storage bin.

how to achive this process in WM. (i already working manual TR it will create two posting)



Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Best Answer
    Jun 26, 2010 at 07:24 PM

    whenever you receive anything to a storage location that is connected to a WM (table T320), then you get stock into the 902 interim storage type.

    if you material is quality managed, then the stock in interim storage type is in Q-status too.

    Once you release the material from Q-status in MM, you will get a posting change notice in WM. You have to process the posting change notice in LU04.

    If you want no Q-status material in WM, then receive first into storage location that is not WM, later perform an extra movement from this storage location to your WM storage location

    Add comment
    10|10000 characters needed characters exceeded

    • That would be my prefferred sequence:

      migo posted -101 and stock place in interim with stock cat -'Q'

      Tr created

      qc has been taken place & confirmed

      creating posting change in LU04.

      Create TO from TR

      move stock to destination bin

      confirm TO