cancel
Showing results for 
Search instead for 
Did you mean: 

Configure CCLM + ATC in SOLMAN 7.2 and ATC Central System in NW752

0 Kudos

Hi,

I’m installing the CCLM + ATC in my Solution manager 7.2 SP7, following the guide:

In the Custom Code Management Step à Set Up Custom Code Management

When activating the Development ERP system (C12) in Expert Activation mode

I get this error with the ATC TOOL, and it does not let me activate the Extractor Quality (ATC)

The C12 system is an ERP 6.0 version EHP4 / NW 701

I understand that the problem is in my version, as you indicate in your post:

https://blogs.sap.com/2016/12/12/remote-code-analysis-in-atc-one-central-check-system-for-multiple-s...,

C12 should be at least a NW 702 true?

That's why I'm not allowed to activate the ACT TOOL because the ATC transaction does not exist in C12?

We have also installed an NW752 SP3 to make it serve as Central Check System, from this Central ATC if we can execute remote code analysis in ATC in older systems as my ERP 6.0 NW 701 is this true?

I understand that it is true, as you indicate in your post:

What is not clear to me is how to configure the Solman 7.2 + NW 752 to be able to launch the remote code analisys ATC in my Satellite Systems?

I have not found any guide that clarifies how to make this configuration.

The only thing that I found in the manual of CCLM, these two scenarios for the Quality Cockpit, I understand that we should install and configure the Scenario 2, right? But I do not know how to do it?

All the information that I have found is to configure the CCLM + ATC in a Solution Manager 7.2 or an ATC Central System to launch remote code analysis in ATC against the Satellite Systems, but I have not found anything that indicates how to configure the Scenario 2 that I understand is the right one for my infrastructure, right?

Thanks in advance.

Regards.

Jordi Arnau.

Accepted Solutions (0)

Answers (2)

Answers (2)

Matias_AV
Participant
0 Kudos

To be able to get the data to Solution manager you need to setup the RFCs (In the solution Manager and other systems) along with its users, roles, etc.

Also you need to complete the Custom Code section in Solman setup, along with other configurations like activating BW Content also from Solman Setup.

Myself im only familiar with the Custom Code section of Solman setup, as the other sections was handled by Basis.

Matias_AV
Participant
0 Kudos

Hello,

From the central system you should be able to check the custom code from a SAP 7.02. And Solution Manager should get the data from the central check system >=7.50.

From what i've seen, the BASIS team have to do some configurations so the ATC central check system appears on SOLMAN, then perform the managed system configuration scenario for the ATC Central Check System and after that you can configure the Custom Code Management scenario also for the ATC central check system. Sadly for BASIS configuration and Managed system configuration i dont have deatailed steps, so you should probably check with your BASIS team or whoever handles the Solman configuration.

Calvin_vdw
Explorer

Hi Matias/Jordi,

I am also looking for information around configuring the integration of SolMan 7.2 to a central ATC.

Could you possibly provide insight as to how this was completed?

Appreciate the assistance.

Regards,

Calvin