Skip to Content
avatar image
Former Member

Change Characteristics

Dear all

would you plz tell me, how to change the control indicators in Master Inspection Characteristics in which i have assigned "Class Characteristics"

as in change mode it shows non modifiable indicators

regards

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • avatar image
    Former Member
    Jun 17, 2010 at 03:58 PM

    As you must be knowing control indicators are automatically picked depending upon the type of class char you used.

    So you have to change the class char itself so that control indicators will automatically change.

    That's how it is.You make have to create a version or new MIC altogather.

    I hope this input will add some value.

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Jun 18, 2010 at 07:52 AM

    is there any option to assign one characteristics to multiple MIC

    also actually i dont want to create version its restricted due to some reasons. any other option to change indicators after assigning the class characteristics

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      requirement is that i have to assign one MIC at different plan with different indicators thats y i need a solution to change the control indicators