0CO_OM_CCA_9 Init data load.

[Former Member]

Hi ,

For 0CO_OM_CCA_9 Datasource which loads the data to ZCCA_C01 infocube directly.

There is data in the cube upto last month.

Since ECC upgarde happened, We have to again initialize data.

Since Infopackage- data load without data transfer is not possible,we have to again load the data for init.

1.Whether we have to delete the data of Infocube and load complete data orjust load last month data through infopackage selection and delete the last month data to do initialization?

Thanks and Regards,

MuraliManohar.

[former_member186445 · Accepted solution]

delete data from cube and do the init again from scratch

M.

[Former Member]

Ok.Thanks.

[Pravender]

It brings cost center's actual data. So loading one month data only can also solve the problem.

Validate previous monht's data after loading and if there is any issue then you have to load complete data.

[Former Member]

What about Second option?

Do we get some problem?

-MuraliManohar.

[former_member186445]

you could, but then you would need to check that you want miss any entries of the last month...

and you should be sure there are no entries for the current month...to be sure you could do a selective deletion in the cube for the current month....

so it's possible, but it holds more risks than a full reinit

M.