Skip to Content
Former Member
Jun 09, 2010 at 07:19 AM




I am trying to consume a web service (which published by a third party, out side of my network) through PI 7.11 . I have created the external definition via the web service WSDL then defined the Service Interfaces, Message Mappings and Operation Mapping in IR. Later i configured the scenario in ID and tested in Test Configuration in ID. It found correct receivers with the payload.

I also generated ABAP Proxy in ECC system and run test in SPROXY. It gave me "RCVR_DETERMINATION.NO_RECEIVER_CASE_BE No receiver could be determined" error message. I have run "http://<saphost>:<port>/CPACache/refresh?mode=full" many times but didnt help. I copied below TRACE message from SXMB_MONI.

I also noticed that there are two lines per test. One is sender and one is receiver but both Interfaces are same and outbound one.

What could be the problem?