06-07-2010 9:58 AM
Dear Team,
Whicle create vehicle master "Error in Internal Number Range" (Elementary action Create Vehicle with Internal Order (DBM) was not executed for vehicle) occured.
I have checked Controlling config, its seems correct still above error message occured. Kindly provide the solution.
Makarand
06-07-2010 10:03 AM
Dear Makarand,
There are few basic things that you can check in the initial go. They are:
1. Check if the action CREA is assigned to DBM1 or your defined primary action matrix. Check in TA: VELOS
2. Check if the internal number ranges are defined for the vehicle object.
3. Check in VELORU if the user is assigned all the roles needed.
If all of these are not working, then we can look into the problem again.
Best regards,
Harsha
06-07-2010 10:03 AM
Dear Makarand,
There are few basic things that you can check in the initial go. They are:
1. Check if the action CREA is assigned to DBM1 or your defined primary action matrix. Check in TA: VELOS
2. Check if the internal number ranges are defined for the vehicle object.
3. Check in VELORU if the user is assigned all the roles needed.
If all of these are not working, then we can look into the problem again.
Best regards,
Harsha
06-07-2010 1:03 PM
Dear Harsha,
Got solution.
In Vehicle Management System (VMS) did not mentioned number range.
(Determine Number Ranges for Internal Vehicle Number).
thanks a lot.
Makarand