Error during Managed System Configuration

[Former Member]

Dear All,

I have installed Solution Manager 7 EHP1 (with SP22) on windows 2003 64 bit platform.

During Configuration in 2nd step of "Managed System Configuration." i.e. check Prerequisite, I am getting error in

Diagnostics prerequisites

During Self check following error found in "Solution Landscape Configuration"

Message : The RFC Read Destination is not available for connection to Satellite System (RC=2).

Action : Please check SAP Note 1106900.

Detail error :

-

---

Severity:Error

Message:The RFC Read Destination is not available for connection to Satellite System (RC=2).

Action:Please check SAP Note 1106900.

Severity:Info

Text:The Technical System SM2~ABAP has no RFC Read Destination defined

-

---

I have check note 1106900, I have given authorization to SMD_RFC user. Actully required authorization was there but made correction according to note.

But problem remain same.

Thanks in advance,

Nirav

[Former Member]

.

[Former Member]

Dear Nirav,

You have to generate the Read RFC to the Managed system.

Please make sure the First step in managed system Configuration- Extablishing connection to satellite system is through.To check this, Do check in SMSY- Whether the RFCs are visible against the client of your system and do test that RFCs.

Feel free to revert back for any issues.

Regards,

Jagan

[Former Member]

Dear Jagan,

Thanks for your quick reply.

I have check 1st step in Managed System Configuration - "Connect Managed System" - I have check the log also I have run it ones again and it is sucess full.

I have checked as you have suggested. RFC test in SMSY is successfull.

I have following RFCs created and in it's assignment in SMSY as bellow :

SM_SM2CLNT500_READ

SM_SM2CLNT500_TMW

SM_SM2CLNT500_TRUSTED

SM_SM2CLNT500_LOGIN

SM_SM2CLNT500_BACK

RFC Read Access : SM_SM2CLNT500_READ

RFC for Change Manager : SM_SM2CLNT500_TMW

Trusted System RFC : SM_SM2CLNT500_TRUSTED

RFC for Solution Manager : SM_SM2CLNT500_LOGIN

SM_SM2CLNT500_BACK is not assigned.

Thanking you ones again,

Nirav

[Former Member]

Hi Nirav,

Well the note 1371222 talks about the issue you are facing now. Please confirm whether you have done all the settings as per the note and made the user adjustment/comparision.

You have to run the managed system setup again and generate RFCs again by setup wizard.

Regards,

Jagan