Measuring Position Unique check

[former_member546319]

Dear All,

I made the required settings in SPRO to make Measuring Position as Unique at Client Level.

When I am creating Measuring Point with same Measuring Position, it is giveing only a warning message IR140.

I did not find this in Message control to make from Warning to Error. Is there any other standard way to make it Error or only through development.

Regards,

MLN Prasad

[Former Member · Accepted solution]

MLN Prasad,

You will not be able to change the message type from warning to error without doing development.You will either have to modify the current message in the program or Use the user exit on Save of the Equipment /FL to generate a Error message.

Regards

Narasimhan