Skip to Content
avatar image
Former Member

Check chars in material inspection setup.

Hi,

In my case i have inspection lot that i can't enter result in the chars. the flag in the 'check chars' in the material inspection setup was 'off'. when i changed it to 'on' is steel i can't enter result to this lot.

what i can do in this case with this lot' i want to enter result in the chars.

Thanks for advise,

Aviva.

.

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • avatar image
    Former Member
    May 26, 2010 at 11:28 AM

    Hi

    MICs are displayed in inspection lot?

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    May 26, 2010 at 11:45 AM

    In this case what you have to do is if lot is already created then this will be applicable from next inspection lot.

    Check the following possibility( I am sure that will not help much but still try once) :

    Go to QA02->click on Reset>save>status will change to CRTD>now again assign the task list & click on sample.save>check the status REL

    Now try to do the RR.

    Add comment
    10|10000 characters needed characters exceeded