cancel
Showing results for 
Search instead for 
Did you mean: 

Production order operation release error

Former Member
0 Kudos

Hi,

I am facing below issue :

when new operations are mnaully added to already released production order, system tries to automatically release the new added operation . System shows new added operation as released but when production order is finally saved tables JEST is not getting updated and we get below error.


No status object is available for ACT 9900424668 0060
Message no. BS001
Diagnosis
When trying to read the status of an object (ACT 9900424668 0060), a system error occurred: For object number OV000043229100000009 there is no status object.
Procedure
Please contact your system administrator.

some time order gets saved w/o above status erorr but when we again go abck to production order in display or change mode i am not able to go to operation screen as it errors OBJECT_NOT_FOUND error as JEST is empty for this opeartion status.

this is happening only for one Order type. Rest of the order types works fine.

Any clues are highly appreciated.

Accepted Solutions (1)

Accepted Solutions (1)

Former Member
0 Kudos

Guys please suggest.

Former Member
0 Kudos

Hi,

Refer note - 94699. Suspect there is some enhancement which might be causing the issue, do a detail check at your end.

Regards,

Vivek

Answers (1)

Answers (1)

former_member196530
Active Contributor
0 Kudos

Dear ,

What is the Status of the Preceding operation ? If it is PREL( pre released operation ) then frist you released the frist operation n then try to add .I think it will happen .

Check the Order Status .It should be realsed -REL

Check in BS02-PP-Status Profile

Check in BS42-Operation Selection Conmdition -REL , LOCKD (ACtive or Not Active )

Try and revert back

Regards

JH

Edited by: Jiaul Haque on May 25, 2010 10:32 AM

Edited by: Jiaul Haque on May 25, 2010 10:41 AM

Former Member
0 Kudos

Hi Jial,

Yes Order status is released. preceding all opeartions are in release status.

Status profile looks ok in BS42 as it is only used for custome statuses and the same z profile is working fine in other order types .

former_member196530
Active Contributor
0 Kudos

Dear ,

Check the following Notes :

1.SAP notes 607203

2.OSS note 32900

3.Check note 1013759 and 1061884. and also analyze

Meanwhile wait few more response from the experts .

Regards

JH