on 05-18-2010 12:04 PM
Hi All,
I have done a batch to batch transfer posting in 309(same material - batch to batch).
At IM level the receiving batch charecteristics have been copied.
When i create a TO from the posting change number using LT05 and check the bin stock status or check LQUA table,the SLED of the receiving batch has the SLED of the issuing batch.
Problem is not with IM stock/WM stock but,only the batch characteristics are not getting copied at WM level.
Please suggest a solution to this issue.
Regards
Deepak
Creating new batch while posting the change?
Check the config for mvmnt 309 to copy characteristics of source batch
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi All,
Stock of the material in IM and WM are as follows
IM sloc - - batch A - 50EA - SLED - 15/5/2010 WM - bin A01 - 50EA
IM sloc - - batch B - 50EA - SLED - 15/10/2010 - WM - bin A02 - 50EA
Scenario is I have done a batch to batch transfer posting of the same material for 20 EA from batch A to batch B in MB1B.
batch charecteristics of the both batches is
After I create a TO from the posting change number.
After the TO creation and confirmation IM stock is
IM sloc - - batch A - 30 EA - SLED - 15/5/2010
IM sloc - - batch B - 70 EA - SLED - 15/10/2010
WM - batch A - bin A01 - 30 EA - SLED - 15/5/2010
WM - batch B - bin A01 - 20 EA - SLED - 15/5/2010 (wrong SLED)
WM - batch B - bin A02 - 50EA - SLED - 15/10/2010
Can someone suggest if there is any configuration settings or this is s standard system behaviour.
Regards
Deepak
User | Count |
---|---|
107 | |
12 | |
11 | |
6 | |
5 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.