Skip to Content
0
Former Member
May 14, 2010 at 10:16 PM

Deletion Flag in APO Loc-Prod

742 Views

Hi

I was trying to set deletion flag = X in MASSD for location dependent products in APO. I then ran DELETE_PRODUCTS but the program in dialog does not seem to run..and in background finshes in 2 sec with no job log. I still see the location products that I was attempting to delete.

The only clue I have is the Location concerned does not have location ID. Final objective is to delete locations. Other dependent TX data is deleted. CCR / OM17 and other re-org reports are run. Relevant CIF models are deactivated before all this.

if you could give some pointers.

Regards,

Loknath