Skip to Content
0
May 12, 2010 at 08:52 PM

Planning Sequence Variant Variable - no Display

88 Views

I have a variable based on a custom characteristic Infoobject. Its set up as Single, Mandatory. This works just fine.

I've used the variable in a filter, and latter in the planning sequence the variable will be filled via a planning sequence variant.

Again this worked fine. Notice I've used the past tense.

NOW, when I open the planning sequence in the modeller, the variants are still able to be selected, but the variable that once was displayed so well , is no longer there. It is still in the filter, it just doesn't display in the planning sequence variant. No errors occur when accessing the variant, or the planning sequence. Other variables in the filter display but this one has gone missing.

I'm trusting that the variable assignment still exists, it just doesn't display. In our Q and Prod environments this doesn't occur. It is only happening in Dev. Not having it display makes it exceedingly difficult to make any changes.

Any thoughts on what might have to be kicked to have the variable display once again ??

Thanks

Edited by: Brent Mawhinney on May 12, 2010 4:56 PM