cancel
Showing results for 
Search instead for 
Did you mean: 

Packing problem in STO

Former Member
0 Kudos

Hello All,

The problem is related to Packing process in case of Stock Transfer Order (STO).After making delivery while doing the packing procedure, in " Handling Unit " supplements 'Handling Unit Group 1' field is not getting populated automatically (under additional data tab) though all the master data against 'Handling Unit Group 1' are maintained.

Please suggest regarding what are the configurations missing.

Thanks & Regards

Priyanka Mitra

Accepted Solutions (0)

Answers (1)

Answers (1)

Former Member
0 Kudos

Can you please check table TVE1.

SPRO>HUM>Basics>Technical Basics>Use handling unit supplements

Edited by: kiranvyarlagadda on May 12, 2010 1:19 AM

Former Member
0 Kudos

Hi,

First of all thanks for your suggestions but I have already maintained all the handling units ranging from for example 00001 to 00500 in the mentioned path and now I want the system to automatically populate / assign these number ranges against Handling Unit Group 1 , Handling Unit Group 2 etc under "Additional Data" Tab of "Pack" in the Delivery Order.

Please suggest.

Thanks & Regards

Priyanka Mitra

csaba_szommer
Active Contributor
0 Kudos

Did you maintain the value in packaging instruction (POP2) in the suitable field (PIKP-VEGR1)?

Former Member
0 Kudos

Hi Csaba,

According to your suggestion we have already maintained the combination of finished good & packing material in the packaging instruction in POP2. Apart from this as per your reply what are the details need to be maintained in the field (PIKP-VEGR1)?

Another thing is in another scenario the handling unit is getting automatically populated in the packing process after delivery where also the above mentioned areas are not maintained, but still it is working properly which is not clear why & how is this taking place.

Please suggest.

Thanks & Regards

Priyanka Mitra

csaba_szommer
Active Contributor
0 Kudos

Hi,

You said the mentioned field is not populated for the HU (transactional data).

I told you that you have to maintiain the desired value it in the master data (packaging instruction), after that you should get the value automatically in your transactional data (HU).

Regards,

Csaba

Former Member
0 Kudos

Hi,

As per my earlier posts I have already maintained all the master data against 'Handling Unit Group 1' for example 00001 to 00500 and the combination of finished good & packing material in the packaging instruction in POP2 are also maintained.

Please note that in another scenario the handling unit is getting automatically populated in the packing process after delivery where also the above mentioned areas are not maintained, but still it is working properly.

The steps I have configured and which is also followed in the working scenario are as follows -

In outbound delivery change mode (T Code - VL02N) go to Pack -> Click on Pack Proposal -> Expand packing instruction -> select 602 -> Create HUs -> Message shown is Handling Units were created -> click on Pack material & select the 'Handling Unit' line -> then select 'Detailed view general' -> then go to Additional Data where in Handling Unit Group 1, value is automatically populated / assigned for example 00027.

In my process only the value for example 00001against each respective HUs are not getting automatically populated/ assigned. How to do this ? please suggest if I am missing any steps while configuration.

Thanks & Regards

Priyanka