Skip to Content
0
Former Member
May 07, 2010 at 07:49 AM

"Error in OPEN_FORM for document xxx" after deleting a printer

135 Views

Hello,

sometimes i have to delete a printer, because of various reasons.

After that, we have some problems, especially in Tx ME23N -> Print Preview.

There i get message no. ME142 "Error in OPEN_FORM for document xxx", because the printer doesn't exists any more.

In the messages (of the document) i see, that the logical destination changes to e.g. $DSRW (this is/was the short name of the deleted printer).

Now i have 2 "solutions" for this conflict:

1) Create a Dummy-Printer with this short name.

2) Create a new message with printer "local"

My question is, do you have similiar problems with the "short name" after deleting a printer?

And what are you doing after deleting a printer?

Best Regards,

Patrick