Error during payroll simulation

[Former Member]

Hello,

Does anyone have any insight on the following error? It occurs when i run payroll for a specific individual under the KTXDM > Processing.

No entries for org unit, job or position in T5KWB

Search in organization structure failed

Check T5KWB for org unit XXXXXXXX or higher-level org unit for XXXXXXXX

Thanks.

[li_zhang · Accepted solution]

Hello cpatel,

Is note 1114015 applied in your system?

Best Regards,

Li

[Former Member · Accepted solution]

HI Li,

actually i was able to get pass that error i just had to link my job to my position in configuration. However i am getting the following error now.

Termination in operation ERROR

20101903

K023****** ERROR

Basic entry in IT :

I am using the schema K000, this error occurs in the sub-schema KALO in the function KO23.

Thanks.

[Former Member · Accepted solution]

Seems to be a master data maintenance issue.....

[ted_dinh · Accepted solution]

Check processing class 20 for the wt it has error on. It should have a value different than '' .

[Former Member · Accepted solution]

Hi Ted can you please elaborate a little more how can i check the processing type 20?

Sorry i am new at HR and don't know my way around it yet.

Thanks.

[ted_dinh · Accepted solution]

SM31 tcode to V_512W_D view - go to the wt in question - double click

[Former Member · Accepted solution]

Hi Ted,

Thanks for the quick reply. I checked the wage type i assigned to my personnel in TCODE PA30, under the infotype Basic Pay.

The Wage Type is M001. When i cheked in SM31 for that wage type there was a value of 2 under the processing class 20.

Did i check the wage type at the right place? or is it managed somewhere else?

[ted_dinh · Accepted solution]

You need to see when payroll errors out in rule 'K023', what wt it's errored out at (run payroll simulation only for this ee with log on). Then check pclass 20 for this wt (doens't necessary have to be the wt in IT0008).

[Former Member · Accepted solution]

Thanks Ted, it worked greate.

Do you know why we have to make this change considering that wage types are standard SAP.

Edited by: cpatel on May 6, 2010 11:30 PM

[Former Member · Accepted solution]

HI Ted

would you happen to know what this error is about?

Termination in operation ERROR

20101903

X045****** ERROR

Basic entry in IT :

i looked into it and it seems that it is using valuation class 25. So i did as u recommended for the previous error, i made sure it was not blank in the table in tcode SM31.

However once i make that change i see this error:

STOP: No rule in key X0451*****

Any idea?

Thanks.

[ted_dinh · Accepted solution]

The values in each pclass have different meaning / purpose. In this particular rule (X045), wt passed to this rule would need to either have value of '0' or '1'. Any value other than this will produce error.

[Former Member · Accepted solution]

HI Ted,

i really appreciate your prompt responses, thanks allot.

I did change the in the PClass to 0 and the error did go away but it produced the next error

STOP: No rule in key X0451*****

I can't seem to figure this one out.

Thanks.

[ted_dinh · Accepted solution]

Is this error produced from the same wt you changed ?

[Former Member · Accepted solution]

No from wage type /101, i tried changing the PClass 25 in there but the error persists.