on 05-05-2010 4:28 PM
Hi I am configuring ChaRM workflow.
For the devloper I have not done any changes in the actions, whereas whenever I 'create transport request' through developer's actions after that the available actions are again back to the old one i.e. 'Set to in development' and 'Cancel Procedure'.
Any pointer to the possible problem.
Regards,
Smita
Hi Smita,
did you look to the following note :
Note 919477 - Normal correction reset to status "created"
Is it the same problem ?
Regards,
Stéphane.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
87 | |
10 | |
10 | |
9 | |
7 | |
6 | |
6 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.