Hello All,
Am doing a file to IDOC scenario.
I have configured the sending system as a party and added a business component, to the BC attached the service interface and also configured the sender Communication channel(CC) as file.
On the receiving end configured the R/3 system from SLD as the business system and configured the receiver CCl. Can see the R/3 logical system in the Adapter specific identifiers at business system.
Pushing the file get an error "Unable to convert the sender service to an ALE Logical System". But choosing "Take sender from Payload" in the receiver CC is resolving the problem, however the sender partner number remains the same as what I have mapped to the control record in message mapping (which is like hard coding).
My questions are:
1. Am I doing the correct config in terms of the scenario. (like using "Take sender from Payload")
2. I tried using identifiers at the party level to convert the sending system, but nothing seems to work. But sending system remains the same as the constant from mapping.
Suggestions would be very much helpful..
--Prashanth
PS: Have gone through many blogs and posts on the forums, but may be I did not see the correct thread. Apologies if I am asking this again.