Skip to Content

number of message can be processed in PO system with in a second?

For the exploration purpose,i got question that how many number of message can be processed in PO system with in a second.Is it hardware dependency or we can regulate the message flow. How can I know these details?

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • Jan 04 at 01:42 AM

    Hello Suresh,

    Maybe your question is the same as how long it would cost to process a message in PO system and how to monitor message count during some time range.

    As far as I know, it should be related to the complexity of the scenario you design in PO system.

    As to a whole message processing, it includes mapping, receiver determination, interface determination, etc.

    The more complex each step is designed, the more time it would cost.

    Regarding how to monitor message processing during some time range, you could go to http://host:port/nwa -> SOA -> Monitoring -> PI Performance Monitoring.

    The smallest aggregation interval is 15 minutes so we cannot figure out the number of messages can be processed in ONE SECOND which is too short.

    Hope info above can be clear to your question.

    Thank you.

    Best Regards, Faison

    Add comment
    10|10000 characters needed characters exceeded

    • Hi Faison,

      Your understanding is very correct.

      I got the requirement to check the system feasibility of the integration server whether it can stand a huge bulk of messages.

      Here I have created a dummy scenario and tested the system and then check the Performance monitoring.

      the processing time in the screen shot gives the estimate of message processing in a second.

      Regards,

      Suresh.

      pic1.png (17.4 kB)
  • Jan 10 at 02:52 PM

    Before installing the system, basically basis people will gather these information. like they will look at the besiness requirement and determine how many messages per day will be processed. what would be the max payload size?

    Based on that they will do the sizing and install the PI system. Tools are available for sizing, you just feed these inputs and you will get the required hardware info.

    Add comment
    10|10000 characters needed characters exceeded

    • Hi Muniyappan,

      System configuration was already done by Basis consultant ,but he was not sure about the hardware configuration can stand against the load or not.After discussion we decided to create test scenario to exactly know the system feasibility.

      Currently we are working on the same.

      Regards,

      Suresh.

  • Feb 01 at 07:52 PM

    It depends on the business requirements, and the complexity to achieve them using technical transformations in PI.
    It also depends on the type of communication is used - RFC, SOAP etc. this is basically done when sizing and performance tuning is done by BASIS.

    Thanks

    Sugata

    Add comment
    10|10000 characters needed characters exceeded