Manuf order-operation-confirmation

[Former Member]

Hello

Do I understand correctly that

1. operation of manufacturing order may have only one confirmation number

2. Partial confirmation can be done many times with the same number until the final confirmation is in place

3. confirmation (quantity , all other details) can be changed later

Thanks

[Former Member · Accepted solution]

Hi Comandante Che Guevara

Yes your understanding is right on first two points

On the 3rd point - after the final confirmation we cannot really change the values but we have to cancel the confirmation(either operation wise CO13 or for the whole order CO15) and then reconfirm with the desired values

If you already know this then yes your understanding is right on all the three points

Thanks

SVP

[Former Member · Accepted solution]

Thanks

Just would like to clarify few points

One confirmation may have many counters (AFRU). Does each of these counters is a partial conformation?

Can I change the confirmation if final confirmation isnt done?

[Former Member · Accepted solution]

Every confirmation have a last change date that may be different from creation date.

[former_member1269942 · Accepted solution]

Dear

yes in AFRu the counter is specify the no of confirmation done against the operation

Counter that enumerates confirmations for an operation. If more than one confirmation was created for an operation then the confirmation counter together with the confirmation number unambiguously identifies the individual confirmation.

And in sap there is no option to change the confirmation there is only create and cancel the confirmation

so if u want to chge the confirmation data so u have to cancel the privious on and create a new one again

and u can chage the confirmation after final confirmation also

Regards

Sachin

[former_member196530 · Accepted solution]

Dear ,

When ever you will perfom confirmation wether Final /Partial /Mile Stone , system genertase counter number against the Confirmation Number .It depends on the type of confirmation you are doing against that operation .Goto CO14 , you can observed that .

Yes you can change the confirmation if the Final Conrimation is not done .In that case you need to cancel in CO13 and do the confirmation with Final Confirmation Selection in CO11N/CO12

Regards

JH

[former_member1269942]

Dear

operation of manufacturing order may have only one confirmation number - Yes opertaion for an order its had only one confirmaton number

Partial confirmation can be done many times with the same number until the final confirmation is in place - YES

confirmation (quantity , all other details) can be changed later -

U can not change the confirmation what u can do is cancel the privous confirmation and again do the new one with changed data

Regards

Sachin