Skip to Content
avatar image
Former Member

Characteristics not within tolerance range: But forced acceptance done

Dear Friends,

I have certain master inspection characteristics defined in the inspection plan.

I have defined a tolerance limit for those characteristics, Upper limit & Lower Limit.

During results recording some of the characteristics are not within the tolerance range.

But the user has done a forced of those characteristic. System proposed to select reject but the user accepted it.

I want to see a report which will tell me which characteristics were forced to closure in a inspection lot.

Regards

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

3 Answers

  • Best Answer
    Mar 31, 2010 at 11:44 AM

    Hello,

    Try this if works for you,

    1. Perhaps you have to take reference from 2 tables QAMR and QASE for this issue.

    2. Look for the field KZBEWERTG in QAMR table. If it is with symbol / it means this particular characteristic has been valuated forcefully.

    3. For the valuation of same MIC look for field MBEWERTG. If it is A then valuation is accepted.

    4. Go on sorting or filtering with above criteria in order to fulfill the requirement.

    5. If you want the exact measured value (reading) pass the same inspection lot number through table QASE and look for field MESSWERT in QASE table.

    Best regards,

    Anand Rao

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Mar 27, 2010 at 05:09 AM

    Dear Anuradha,

    Pl checked whether MCXD & MCXB reports help you or not, these std reports gives you analysis of Inspection characteristics whether rejected or accepted.

    Best Regards,

    Shekhar

    Add comment
    10|10000 characters needed characters exceeded

  • Mar 27, 2010 at 03:36 PM

    I think you'l need to use SQVI. Since the user valuated the out-of-spec as acceted, the transactions mentioned won't work as described since the field "Valuation" will show as accepted.

    You can search by characterisitcs how in the provided structures and get counts on number above spec and number below spec. That might help you. You may need to use the flexible analysis area to create yourself a speciifc analysis for this.

    If that isn't working, you might need to use SQVI to create a report that can then be exported to excel where you can make specific checks between the value and spec fields.

    FF

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      Hi Anuradha,

      When you are forcefully closing MIC, system is giving only the message so I doubt whether that analysis is available. You can have the details of the results recorded.

      BR

      Shekhar