Skip to Content
avatar image
Former Member

EWM Layout oriented storage control config task cannot be quit

Hello EWM Friends,

after a difficult way to the cobfig, i create two warehouse Tasks in the layout oriented storage.

But now i cant quit the first active Task.

(Warehouse Task cant not be quit due active Produkt Tasks exists)

I fear the the use of the same start locator might be the Problem.

Have anybody a hint or solution for me.

Thanks in advance

Kai

rtjv4.png (4.6 kB)
dn8cd.png (13.5 kB)
xnptr.png (76.4 kB)
Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

4 Answers

  • Dec 01, 2016 at 03:41 AM

    Hi

    First confirm the task 33 and system auto change the location and then you can confirm WT32.

    As its LOSC system create 2 task 1 waiting and 1 active. Try issue come please post.

    Regards

    Suraj

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Dec 01, 2016 at 11:00 AM

    Hello Suraj,

    the Task 33 is not active (Status B), therefore it cant quit.

    On the other side, the process require the Transport from GR-Zone to the Transfer Location 0041-01-01. Then the task for forklift to store the HU has to be active.

    Best regards

    Kai

    Add comment
    10|10000 characters needed characters exceeded

    • Hello Kai,

      according to your screenshot task 33 is active, 32 is not active.

      But as per you screenshot 2 you try to confirm 33 and the system is giving you the error message, which is strange. Because everything looks as it is supposed to. That the WT 32 still shows the source storage bin GR-ZONE is ok, as long as the WT 33 is not confirmed. Once this is done, the source storage bin in this WT should change to 0041-01-01.

      From what I can see it all looks alright, except the error, of course. Did you check in the HU, if it shows any other WT related to it?

      Brgds

      Juergen

  • avatar image
    Former Member
    Dec 01, 2016 at 12:28 PM

    Hello Jürgen,

    thx for your answer. I check that other WT is related to this. But is not the case.

    I have to say that i am a "Beginner" in EWM with Little knowlegde in EWM. Maybe i did some error during creating the Hu himself.

    It is right that both WT have the same start locator "GR-Zone"?????

    Thx for our help in advance. Hope you will find a solution.

    BR Kai

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Dec 05, 2016 at 06:47 AM

    Hello EWM friend,

    Problem is solved. I find the error in the warehouse master data of the warehouse type

    Best regards

    Kai

    Add comment
    10|10000 characters needed characters exceeded