Xpath doubt

[Former Member]

While using EX expression in X path, how do we assign the receiver ? I saw many blogs where the condition is given in Left operand and the middle operand is EX. But I don't see where they have specified receiver ? Do we have columns after the right operand to enter the receivers ? And if we have multiple receivers and multiple conditions then do we have to use multiple lines to assign multiple receivers next to the condition ?

Midhun

[Former Member · Accepted solution]

Hi, Midhun

In Condition Editor you must specify your condition to determine your receiver, but only your condition.

In Receiver determination screen, at the same line where you have introduced it, you must put your receiver service and parte, if it's necesary.

Regards,

CArme.

[Former Member · Accepted solution]

Thanks Carme

So in the line in which we introduce it we need to put the receiver details. So if we have multiple recievers then how do we go about it ?

Should we create a new line in the Receiver Determination screen under the first receiver, enter the receiver name and then click on condition editor and go to conditions ? Is that how its done ?

Midhun

[Former Member · Accepted solution]

Yes, Midhum, that's correct.

Each line in your configured receiver means, one new condition and one new receiver when this condition becames true (like an if) .

After that, if none of your conditions it's true, you can specify an receiver by default , return error in message monitor or end message without error

Regards,

Carme Alentorn

[Former Member · Accepted solution]

I don't know why but I am getting this error repeatedly when I try to close the thread

" An error has occured while assigning points. Please refresh the thread view and try again. "

I will try later.

Thanks for your help