Skip to Content
0
Former Member
Mar 09, 2010 at 03:00 PM

Serial number issue - Updating MASE table with a new lower value

391 Views

Hi Experts,

My problem is as below :

My existing entry in MASE table for material XYZ is 11000.This number is not to be seen in IQ03,system says it does not exist.Possible it was entered manually before.Earlier to this,we were using 4000 series which were generated automatically.

Now we want to continue using the 4000 series,but the MASE table entry is not getting changed.Am aware of the solution to this problem given in this forum.When i try to change the serial number ,MASE is getting updated with higher value than 11000 & not with alower value which is my requirement.

There is also an option of changing the value in debugging mode but that is not recommended.

Please advise.Points assured for suitable answers.

Regards

Afroz