on 03-03-2010 11:50 AM
Hi all
I am receiving the following error when I try to do a INIT load on extractor 2LIS_01_S005:
LIS updating is still activated (client abc ) M + 25
I have read other SDN posts and I have made the change in both our DEV source systems in TCODE LBW1 to No Update, but I am still getting the error. I am able to do a full load on my InfoPackage but no INIT.
I would appreciate any help or suggestions.
Thanks
See OSS Note 168131.
Symptom
Using report RMCSBIWC you want to generate the delta update in the LIS in the OLTP System. The system generates message M+025:
'LIS updating is still activated'.
Cause and prerequisites
The standard update for the affected structure is still active in at least one client of your OLTP System.
Solution
To be able to generate the delta update for an information structure, you must deactivate the update of this information structure temporarily in all clients.Deactivate the update using the LIS Customizing or report RMCSBIW0 (TCode LBW1 see Note 146294) in ALL clients of the OLTP System in which the information structure is updated.You can activate the update again after generation.
Edited by: Pravender on Mar 3, 2010 5:28 PM
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Dear Pravender Kumar,
I did exactly like you have mentioned.
I got the error then i deactivated the update and the load went him.
Then i changed the update back to its original setting(Asynchronous updating) again i am getting the same error. Can i leave the Info structure as "no update"what will be the impact of it?
I have also cleared the delta queues.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Please check the tables of the LIS structure. There are 3 tables created for LIS (one for full and 2 for delta load),i think those tables are S005BIW1 and S005BIW2 .Please see whether the structure of these two tables is similar i.e order of the fields. If the fields are in different order, i think you may need to change the structure (since it is a standard table,you need object key to change the structure) .Once you make both tables are similar,repeat the steps for the init again
Hope it solves your issue.
Thanks.
Hi Pravender
Like I said, I have made both my source systems inactive but I still get the error.
Thanks
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
95 | |
11 | |
10 | |
9 | |
9 | |
7 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.