Unit of measure - rounding off during creation of planned order

[Former Member]

Dear All,

We have defined one material OIL in MM41 and its UoM is EA also we have put alternative UoM is L(liter).

now we create BOM of semifinished material we use this oil as a component and enter its value in decimal points.

e.g 0.375 EA

During planned order creation or REM backflush system convert this quantity to 1 EA ,WE dont want this automatic conversion .

We have uploaded all master data in production and now it is very difficult to change all BOM

So what is the solution of this that system can not convert qty (rounding off).EA

Kindly reply

Sunil

[Former Member]

Dear Bala,

I hav etried same but it is not working.

Thanks for the reply

Sunil

[former_member199502]

Hi Sunil,

IN CUNI Transaction Field Decimal Places is for displaying the decimals,there is a decimal place Rounding off field below,there try to maintain 3 decimals and check whether it is working.

One more thing is Unit EA will be used always as non decimal unit,But i dont know in your buisness how for unit EA there is a decimal qty

Edited by: Girish Adaviswamy on Mar 2, 2010 10:59 AM

[Former Member]

Dear Girish,

Yes your answer is correct and i checked it works fine.

Thanking you very much

Sunil

[Former Member]

Hi Sunil

1. In CUNI transaction, Click on the Unit of measurement button, there you can find 'EA', then select EA and go to details, you can find a field "decimal places", there you enter 3 and save it.

2. Again run the MRP, after MRP run check the results in planned order.

Regards

Bala