Problem when record inspection result using fiori

[former_member284946]

Hello QM expert,

Can anyone tell me what happened with the case down below

I created Inspection plan with MIC using sampling procedure fixed 1 sample (Acceptance number = 0 and valuation mode 100)

When I tried to record the result for inspection lot via SAP GUI, it works good for valuation (valuate rejected when the result out of spec and accepted when the result is in the range)

But when I was using fiori app "Record Inspection Results" the valuation after record the result was wrong. It always valuated Accepted even I input the result out of spec. (test by same inspection lot)

but when I was using sampling procedure fixed 2 sample (Acceptance number = 0 and valuation mode 100) it works good for both (GUI and Fiori app)

Could you please help me with this case ?

[NC2011]

You have not entered a value in the non-conforming units field, so SAP thinks the number of non-conforming units is 0, which is less than the reject number.

In SAP GUI, SAP automatically fills in the non-conforming units field. In the Record Inspection Results App, it does not. App users will need to enter the number of non-conforming units directly.