Skip to Content
avatar image
Former Member

Change in PO after Release

We want to TICK/UNTICK Goods Receipt / Delivery Comp option of delivery Tab after release of PO (without derelease the po). is it possible (by configuration or standard)?

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

6 Answers

  • avatar image
    Former Member
    Feb 15, 2010 at 09:20 AM

    Hi

    This depends upon if versin management is active in PO or not ? Means after every change in the released PO it goes for rerelease again.

    If you are not using version management then after release of PO change it inME22N again so version is not created and Po shows in released status only

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Feb 15, 2010 at 09:14 AM

    Hi,

    i did t understand... whats u r explaning.. can u explain me clearrr...

    Regards,

    Anthyodaya.

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Feb 15, 2010 at 10:05 AM

    As per current configuration, we are not able to modify the release PO. Many times we need to block the receipt of mateial against few released PO. We also dont want to do the same by derelease the post and modify the qty etc

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Feb 15, 2010 at 11:41 AM

    Hi,

    1. You change the release indicator in PO release procedure

    2. After doing that you can make the required changes and rerelease the PO.

    Regards

    Ashish

    Add comment
    10|10000 characters needed characters exceeded

  • Feb 15, 2010 at 12:33 PM

    Hi,

    If u have release indicator 1 then u can not change in PO without derelease it.

    You can use mass maintence for this

    use T code MASS and object BUS2012 and MASSEKPO-ELIKZ ...make it complete.

    Hope Help U !

    Regards,

    Pardeep Malik

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Feb 15, 2010 at 06:19 PM

    Hi,

    Go to:

    SPRO - MM - Purchasing - PO - Rlease Procedure for PO - Define Release for PO - Release Indicator

    1. For Release ID "R" - Make Changeable column as "3" and make % Value change as 0.01%.

    2. Save and Exit

    3. What this will allow you to do, is to make changes like "delivery completion indicator" etc. However, if the someone tries to change the value of the PO, it will re-trigger approval.

    Hope this would be of help.

    Thanks and Regards,

    Anirban

    Add comment
    10|10000 characters needed characters exceeded